Okidata MB461 MFP Toner | Compatible 44574701 Cartridges

MB461 MFP

Print, scan, copy and fax all run through one black cartridge on the Okidata MB461 MFP, a monochrome multifunction machine built for busy offices. Two toner fills fit it: the standard 44574701, rated at 4,000 pages, and the high-capacity 44574901 at 10,000 pages. The image itself is formed by the 44574301 drum unit, a separate long-life component that keeps working through several toner swaps before it asks for attention.

That single-supply layout suits a shared front office where the same machine takes fax traffic in the morning, walk-up copies at midday and ordinary document printing in between. Nobody has to think about which consumable a job needs: every page the MB461 MFP produces, however it arrives, draws on the same black toner, so keeping this machine fed is a one-line ordering task.

Toner Cartridges for MB461 MFP

Cartridge	Color	Page Yield
44574701	Black	4,000 pages
44574701 — Black, 3 Pack	Black	4,000 pages each
44574901	Black	10,000 pages
44574901 — Black, 3 Pack	Black	10,000 pages each
44574901 — Black, 5 Pack	Black	10,000 pages each
MB461 MFP Toner Cartridge — Black	Black	See product page
MB461 MFP Toner Cartridges — Black, 5 Pack	Black	See product page

The drum is bought on its own cycle: the 44574301 drum unit is the only imaging component this machine needs beyond toner.

Which cartridge should you buy?

On a shared machine the high-capacity cartridge usually wins the argument. The 44574901 carries two and a half times the fill of the standard cartridge, so the toner light interrupts work far less often and the cost of each printed page drops. The 44574701 still makes sense where the MB461 MFP sits at a quiet desk and a cartridge lasts for months — there is no prize for toner sitting in a machine that barely prints. Multipacks suit offices that reorder on a schedule: a three- or five-pack on the shelf means the next swap never waits on a delivery, and the per-cartridge price falls again.

Chip, toner and everyday use

Push a fresh cartridge in until it clicks; a half-seated cartridge is the usual reason a printer keeps reporting low toner after a swap, and one firm reseat lets the counter recalibrate. Page ratings assume ordinary document coverage, so a month of dense fax logs and full-page forms will land short of the headline figure while light memo traffic can pass it. When output starts to thin near the end of a cartridge, rock it gently from side to side to redistribute what is left, and store spares flat, sealed and out of direct light so the toner stays free-flowing.

Frequently Asked Questions

Which toner fits the Okidata MB461 MFP?

Either of the two black cartridges listed above: the standard 44574701 or the high-capacity 44574901. Printing, copying, scanning-to-print and fax output all come from that one cartridge, and the 44574301 drum underneath it is replaced separately, on a much longer cycle.

Copies from my MB461 MFP come out too light. Is the toner empty?

Not necessarily — check the copy density setting on the control panel first, because a light density choice washes out every copy while leaving computer prints untouched. If prints sent from a computer are also pale, then the cartridge really is running down and a replacement is due.

Does a new toner cartridge include the drum?

No. Toner and drum are independent parts on this platform. A toner swap changes only the toner; the 44574301 drum stays in place until its own service life ends, which is normally after several cartridges have passed through the machine.

Standard or high-capacity for a busy shared MB461 MFP?

High-capacity, in most cases. At 10,000 pages the 44574901 stretches each swap interval and lowers the per-page cost, which is exactly what a machine serving a whole office needs. Drop to the 44574701 only if the printer's workload falls away for long stretches.