Lanier 330

One rung above its smaller Lanier sibling, the Lanier 330 is a departmental multifunction system that takes on heavier copy and print workloads while staying easy to live with. Everything it prints runs through a single black cartridge, the Type 2120D, ordered under Ricoh part number 888169 and rated at up to 11,000 pages. That long interval between swaps suits a machine a whole department leans on, and the 330's straightforward control panel means nobody needs a training session before walking up to it.

The 330 earns its place on shared floors: mixed teams copying handouts, printing reports and scanning documents through the day. Because the hardware under the Lanier badge is Ricoh's proven multifunction engineering, output stays consistent even when the queue is long, and the simple interface keeps people moving instead of bottlenecking at the panel. For an office standardizing on one dependable departmental unit, that mix of capacity and plain operation is the draw.

Toner Cartridges for Lanier 330

Cartridge	Color	Page Yield
888169	Black	Up to 11,000 pages
888169 — 2 Pack	Black	Up to 11,000 pages per cartridge
888169 — 4 Pack	Black	Up to 11,000 pages per cartridge

Which cartridge should you buy?

With one cartridge covering everything the 330 prints, the real choice is how often you want to think about toner. A single 888169 cartridge is the straightforward pick for a machine on a moderate monthly volume. Busier departments usually move to the 2 Pack: two cartridges in the cabinet mean a low-toner warning never turns into a stopped job, and the cost per cartridge works out better across the pair. The 4 Pack suits floors that burn through the roughly 11,000-page rating quickly, or stock supplies centrally for several machines. Whichever size you choose, the cartridge inside is the same Type 2120D — only the box count changes — so there is no compatibility gamble between pack sizes. Keeping one spare ahead of the installed cartridge is the habit that keeps a departmental machine like this from ever sitting idle at the wrong moment.

Chip, toner and everyday use

Each Type 2120D cartridge carries a chip the 330 reads on install, so the panel reports toner levels and recognizes the replacement without manual resets. Seat the cartridge firmly until it clicks and the machine handles the rest. Page ratings assume about 5% coverage, so dense reports and heavy graphics will land fewer pages than the headline figure. When output starts to fade near the end of a cartridge, slide it out and rock it gently from side to side — redistributing the toner that remains often restores even printing for a while longer. Store spares flat, still sealed, away from heat and strong light.

Frequently Asked Questions

Which toner cartridge does the Lanier 330 take?

One cartridge covers everything: the Type 2120D in black, Ricoh part number 888169. It is sold here as a single cartridge and in 2 Pack and 4 Pack boxes, and every version is the same cartridge rated at up to 11,000 pages.

How long will one cartridge last in a busy department?

The rating is up to 11,000 pages at roughly 5% coverage. Departments printing dense documents will see fewer pages, while lighter memo-and-email output can stretch a cartridge further, which is why most 330 owners keep a spare from a multipack within reach.

Can one spare cartridge serve other machines in our office?

Very likely, if they run on the same platform. The 888169 also fits the Ricoh Aficio, Gestetner and Savin models listed below, so a single spare can cover several machines instead of stocking a different cartridge for each badge.

Print is fading on one side. Is the cartridge finished?

Not always. Uneven fading usually means the remaining toner has settled; remove the cartridge, rock it gently a few times to level the toner, and reinstall it. If output stays pale after that, the cartridge is genuinely near the end of its roughly 11,000-page life.