Xerox
Compatible Xerox WorkCentre 133 Laser Toner Cartridge Black
- Page Yield:
- 30,000 Pages
- Availability:
- In Stock
- Shipping:
- Free Shipping
- Page Yield:
- 30,000 Pages
- Availability:
- In Stock
- Shipping:
- Free Shipping

/>

Compatible Xerox WorkCentre 133 Laser Toner Cartridge Black is designed and tested to ensure optimum performance and outstanding productivity
Xerox Black toner cartridge is designed to compatible with Xerox CopyCentre: 133 133C 123 128 WorkCentre: 123 128 133 Pro M123 Pro M128 series printers and yields up to 30000 pages. Cartridge offers the best image quality and most reliable printing without interruption.
Features:
006R01184. It is the black cartridge designation for the WorkCentre 133, and this listing is one compatible cartridge rated at up to 30,000 pages. Your machine's supply display and the old cartridge's label will both show that number.
At 3,000 pages a month, about 10 months. At 4,500 a month, roughly 6 to 7 months. The estimate assumes everyday text coverage; a 133 copying dense documents all day will lean toward the shorter end.
Yes — it is one cartridge for the platform: CopyCentre 133, CopyCentre C123, CopyCentre C128, WorkCentre 133, WorkCentre M123, WorkCentre M128, WorkCentre Pro 123 and WorkCentre Pro 128.
Often it is just settled toner. Take the cartridge out, rock it gently side to side, and refit it. If density evens out, there is life left; if the whole page stays pale, the cartridge has reached the end of its rated life and this single replaces it.
At $88.78 — about 0.30 cents per page — the single suits a machine whose workload is new or modest, a one-off gap in your stock, or a first run of a compatible cartridge before you commit to a box.
A 1-year warranty and free returns for a year. All the wording sits on our shipping and returns page, and support works Monday to Friday, 9 AM to 5 PM CST.
It can be, but test the paper first. Damp or poor-quality stock picks up toner unevenly and can haze a whole page even with a sound cartridge fitted. Load fresh, dry paper from a sealed ream and copy the same original again. If the haze vanishes, the paper was the problem; if it persists on fresh stock, the 006R01184 is the likely cause and this single is the replacement.
Yes. Print quality is the cartridge, the paper and the machine acting together: paper stored in a humid room absorbs moisture and prints flat and dull, while the same 006R01184 on dry stock looks crisp. Keep paper sealed until it is loaded, store it in the same room as the WorkCentre 133 where possible, and suspect the stock before the supplies when quality dips suddenly across every job.
A fitted 006R01184 tolerates idle weeks without damage. The toner inside can settle during a long break, so the first pages afterwards may look lighter than usual; print a few ordinary pages and the density normally comes back as the cartridge works. Long gaps between uses are a reason to expect a slow first morning, not a reason to replace a cartridge that still has life in it.
The copy density control decides how much toner each page carries. Running copies a shade darker than standard steadily spends the 30,000-page rating faster, because every page takes a heavier coating; running them lighter stretches the cartridge but can wash out faint originals. Set density for legibility on your typical documents and accept the trade either way, rather than chasing the rating with settings that make output hard to read.
The WorkCentre 133's single-cartridge listing: one compatible black 006R01184, $88.78, 30,000 pages, sent from our Illinois, Pennsylvania, Georgia or California warehouse. For standing stock, the 006R01184 5-pack for the WorkCentre 133 brings cartridges down to $73.99 each. The wider platform range is on our Xerox toner page.