Clever Supplies brand products are made in the USA! Why pay more for cheaper product with a high defective rate? You will end up having to send it back to the manufacturer. Your time is valuable. Get a quality product that you KNOW will work. Purchase the Clever Supplies Compatible for Kyocera-Mita TK-477 Black Toner Cartridge and experience the difference! All Clever Supplies brand products are backed by '100% Quality Satisfaction' 1 year warranty against defects in materials and workmanship for all toner products. Free tech support for any problems for all Clever Supplies brand products. The use of Clever Supplies brand replacement laser toner cartridges and supplies does not void printer warranty. Premium Quality Replacement Toner Cartridge is made by ISO9001 Certified Factory to Meet or Exceed OEM Standards. These units are manufactured 100% brand new with all new parts including OPC drums, wiper blades, a smart chip and other internal parts, they are an economical alternative to expensive OEM TK-477 Compatible Toner Cartridges. The Compatible Toner Cartridges will produce the same amount of page yield as an OEM cartridge would. This is a Compatible for Kyocera-Mita TK-477 Toner Cartridges Black guaranteed to perform with Kyocera-Mita Laser Printers. It replaces the original Kyocera-Mita TK-477 Black. The use of compatible replacement Cartridges and supplies does not void Printer Warranty. Our Compatible for TK-477. Cartridge is a replacement for OEM Kyocera-Mita. We offer a 100% Quality Satisfaction Guarantee on our Compatible for TK-477 Laser Toner Cartridges and supplies. For use in the following printers: CS255, CS305, FS-6525MFP, FS-6530MFP, TASKalfa 255, TASKalfa 305
Frequently Asked Questions
How do I confirm TK-477 is the number my printer wants?
Peel the old cartridge out and read the label on its top face: TK-477 is the designation printed there. You can also print a supplies status page from the menu, which lists the same type. If either source shows TK-477, this single cartridge at $52.06 is the correct item.
What should the first pages look like after I install it?
Expect the same depth of black you got from a fresh original cartridge: solid blacks on headings, clean greys on shaded forms, no streaking down the margins. Run a status page and one ordinary document; if both look right, the cartridge has seated and fed correctly.
Why did the low-toner warning stay on after the swap?
The warning clears once the machine registers the new cartridge, which can take a page or two of printing. Open and close the front cover once if it lingers. A warning that survives several pages with a TK-477 installed is worth a call to our support line, staffed Monday through Friday, 9 AM to 5 PM CST.
My prints look light even though plenty of pages remain. What gives?
Light output mid-life is usually toner settled unevenly, not an empty cartridge. Take the cartridge out, tilt it left and right a few times to loosen the powder, and reinsert it. Also confirm the printer is not set to an economy or draft density, which thins output by design.
Is any setup needed beyond sliding it in?
None. There are no settings to change and nothing to register. The exchange is: front cover up, old unit straight out, new TK-477 in until it stops, cover down. Most people are printing again inside two minutes.
What protection backs this single cartridge?
A one-year warranty and free returns for one year. If the unit fails early or arrives damaged, contact us rather than discarding it. Stock ships from the closest of our IL, PA, GA and CA warehouses, with timelines and return steps on the shipping and returns page.
How many months does a single TK-477 typically cover in a small office?
Work it out from the 15,000-page rating. An office printing around 1,000 pages a month gets well over a year from one cartridge; at 3,000 pages a month it is roughly five months. Your printer's page counter gives the honest figure: note the reading at install, and the next swap date tells you exactly how long a TK-477 lasts in your real workload.
Should I open the cartridge and check it before the old one runs out?
No — leave the TK-477 sealed until the day it goes in. The packaging protects the powder and the cartridge's seals; opening early gains nothing and risks dust or moisture reaching a unit that then sits waiting. Check the part number on the outside of the box instead: if the box says TK-477, the cartridge inside is the one your printer asked for.
Our pages carry big shaded forms. Will we still see 15,000 pages?
Probably not, and that is normal rather than a fault. The rating is measured at standard coverage; a page that is half shaded table uses several times the toner of a plain letter. Offices printing dense forms, bold graphics or board-style packs should budget on a lower figure per cartridge and judge the TK-477 by cost per printed page, not pages alone.
What is the sensible way to dispose of the old cartridge?
Put the spent unit into the box the new TK-477 came out of, seal it, and send it out with your office's toner recycling or general disposal stream. Keeping the empty boxed avoids stray powder on hands and desks. Hold onto it until the new cartridge has printed cleanly for a day or two, so the old unit is still on hand if support asks about it.
About This Cartridge
A single black TK-477 compatible toner cartridge for FS-6025 owners, also fitting the FS-6030 and TASKalfa 255. Sold by Kyocera-Mita specialists at Clever Supplies, each unit is rated for 15,000 pages and priced at $52.06 — the straightforward one-at-a-time replacement for a printer that has just run dry.
See Compatible Printers
Read more about our ink!
