MFC-8300J

The MFC-8300J gives you a real choice of cartridge size. The high-yield TN460 is the long runner, with the genuine OEM version rated for approximately 6,000 pages, while the standard-yield TN430 covers lighter printing, with the genuine OEM version rated for approximately 3,000 pages. Both cartridges seat into the same DR400 drum unit, rated for approximately 20,000 pages on the OEM listing, so the drum is a separate part with a much longer life than either toner cartridge.

Volume decides this purchase, not the printer. A machine that prints every day will go through a standard cartridge quickly, and each swap is a small interruption; the high-yield cartridge stretches the gap between swaps and lowers the cost of each printed page. A machine that prints a few pages a week has the opposite problem: a big cartridge sits half-used for months. The MFC-8300J lets you pick the size that matches the workload in front of it, and the drum stays out of the decision entirely until its own service life ends.

Toner Cartridges for MFC-8300J

Supply	Color	Yield
TN460	Black	6,000 pages
TN430	Black	3,000 pages
TN460	Black	See product page
TN460	Black	See product page

Drum units listed on this page:

DR400 — drum unit, rated for approximately 20,000 pages
DR400 — drum unit

Which cartridge should you buy?

Count the printing first. If the machine runs daily, start with the TN460 high-yield cartridge or the TN460 two-pack: fewer swaps, fewer orders, and a lower cost per page. If the machine prints a few times a week, the TN430 standard cartridge is the better fit, and you can step up to the TN460 later without changing anything else. The DR400 drum unit is independent of this choice and is replaced only when its own life ends, rated for approximately 20,000 pages on the OEM listing. Compatible cartridges carry a 1-year warranty and 1-year returns. Buy the size that matches the next few months of printing, not the size you think you ought to want.

Chip, toner and everyday use

Install a cartridge the same way every time and it becomes a one-minute job. Open the front cover, pull the old cartridge out by its handle, and slide the new one in until it seats. If the printer reports a cartridge it does not recognize, take the cartridge out, check that the chip contacts are clean and dry, and seat it again firmly. Keep a spare cartridge in its sealed bag, flat and out of sunlight, so it is ready when the current one runs out. Yields are rated at 5% coverage, so pages packed with text and graphics use toner faster than the rated figure suggests. When output fades evenly, change the toner; when a single band or streak repeats down the page, look at the drum.

Frequently Asked Questions

What is the difference between the TN430 and the TN460?

Both fit the MFC-8300J. The TN430 is the standard-yield cartridge, with the genuine OEM version rated for approximately 3,000 pages, and the TN460 is the high-yield cartridge, with the genuine OEM version rated for approximately 6,000 pages. Pick the TN430 for light printing and the TN460 when the printer runs every day.

Does the MFC-8300J use a separate drum unit?

Yes. The DR400 drum unit is a separate part from the toner cartridge, rated for approximately 20,000 pages on the OEM listing. You replace the toner several times before the drum needs changing, and a drum change is a separate job.

Can I use the compatible TN460 instead of the OEM cartridge?

Yes. The compatible TN460 cartridge and the TN460 two-pack are listed on this page alongside the genuine OEM cartridges. Compatible cartridges carry a 1-year warranty and 1-year returns.

The prints look faded. Is it the toner or the drum?

Even fading across the whole page usually means the toner cartridge is running out. A sharp line or band that repeats at regular intervals down the page points to the drum. Change the toner first; if the mark stays, the DR400 drum is the next part to check.