HL-730
On the Brother HL-730, print quality lives or dies with one part most owners rarely think about: the drum. This monochrome laser printer feeds from the TN200HL toner cartridge, while a standalone DR200 drum unit carries the print surface and is replaced independently of any toner cartridge. The drum listed on this page is the genuine Brother unit, rated for 20,000 pages.
An HL-730 that has printed happily for years can start looking tired for two completely different reasons, and they are worth telling apart. Toner running low makes everything pale and patchy across the whole sheet. A tired drum leaves evidence of a different kind — the same smudge cycling down the page, thin vertical lines, or a dull film behind the text. Owners who learn to read those signs keep this printer producing crisp pages with nothing more than the right supply at the right time.
Toner Cartridges for HL-730
The HL-730 prints with the TN200HL toner cartridge. The part stocked on this page is the imaging drum below, sold on its own.
Drum unit
- DR200 — genuine Brother drum unit, black — 20,000 pages
Which cartridge should you buy?
Use the page itself as the diagnostic tool. A defect that repeats at the same spacing on page after page is printed by a mark on the drum surface, and no amount of new toner will cure it — that is the moment to buy the DR200. Even, overall fading that improves when the cartridge is rocked side to side is a toner symptom instead. Because the drum is rated for 20,000 pages, it is a rare, deliberate purchase rather than a routine one, and fitting one to an HL-730 with a healthy toner cartridge usually restores the output quality the printer had when it was new.
Chip, toner and everyday use
A new drum goes in dry and clean: lift it by its frame, never by the drum surface, and keep it out of strong light while it is out of its packaging. Seat the toner cartridge firmly into the drum until it locks. If the underside of your prints picks up loose toner in the first few pages after a drum change, run a few plain pages through — the machine clears its path quickly. Keep the old cartridge only if it still prints evenly; a dying toner in a new drum makes the new drum look guilty.
Frequently Asked Questions
What drum unit fits the HL-730?
The HL-730 takes the DR200 drum unit, rated for 20,000 pages. It is a separate part from the TN200HL toner cartridge.
How can I tell a worn drum from low toner on an HL-730?
Repeating marks, streaks that run down the page and gray shading behind text point to the drum. Even fading across the whole page points to toner.
Does the DR200 come with toner included?
No. The drum is the imaging unit only; your existing TN200HL cartridge seats into it, and toner is bought separately as needed.
Can I keep printing with a worn drum?
The printer will run, but output keeps degrading — background shading deepens and marks repeat. A replacement drum is the fix once toner has been ruled out.
More printers that use the same cartridges
These Brother models share the same drum unit: HL-720, HL-730dx, HL-760, HL-760PLUS, IntelliFax-2600, IntelliFax-2750, IntelliFax-3550, IntelliFax-3650, MFC-4300, MFC-4350, MFC-4450, MFC-4550, MFC-4600, MFC-4650, MFC-7750.
